Carlson Software Forum

I often move my points numbers with the elevations and descriptions around to clear up the drawing.

Is it possible to have them blocked together as I plot them? I dont mean all the points blocked together I mean have each point blocked with its own elevation and description together.


It would make it a lot easier to move them around.

Thanks

Under SETTINGS, down to "Carlson Settings", them pick the first radio button"General Settings". On that pop-up check "Group Point Entities".
To move the point blocks, go to POINTS and down to "Move Point Attributes With Leader". You can then move the point block without corrupting your coordinate file and it gives you a nice leader line back to the point node. (Once you erase the points from the drawing and then reload then, all of the point blocks will be back at the nodes.)