I'm trying to use the best fit centreline command (CS 2014 Embedded AutoCad). This command has great potential, however the tangents are not at right angles to the Rad pts. It's too bad that the results pop up doesn't show the BC/EC points.
Is there a way to calculate proper centrelines similar to the C&G Tan arc Tan routine?
Best Fit Centreline
Moderator: Carlson Support
1 post
• Page 1 of 1
Best Fit Centreline
by offinthewoods2 » Wed Aug 06, 2014 1:49 pm
- offinthewoods2
- Posts: 1
- Joined: Thu Apr 17, 2014 6:55 pm
- Location: New Brunswick
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users