Problems creating a block

Moderator: Carlson Support

Problems creating a block

Postby rleslie » Fri May 22, 2020 4:46 pm

I have just recently upgraded to Carlson Survey 2020 OEM and I’m unable to create a block. After I select my objects I get the following message: “WBlock operation rejected due to a proxy object that does not allow copying”

The block is just straight line work. It doesn’t even have text. I tried to copy the linework to the clipboard and that operation also failed. I would greatly appreciate any assistance to correct this matter.
rleslie
 
Posts: 1
Joined: Fri May 22, 2020 4:11 pm
Location: Foxborough, MA

Re: Problems creating a block

Postby tmist » Fri Jun 05, 2020 3:28 pm

I had this same problem with one clients drawing and it was maddening. The only thing that worked was to save off the clients drawing as a 2004 DXF and then open a blank DWG and insert the entire other drawing. It actually worked and removed all the objects in the clients drawing. Good luck !
tmist
 
Posts: 3
Joined: Thu Jun 04, 2020 10:28 pm
Location: houston


Return to Survey

Who is online

Users browsing this forum: No registered users

cron