Page 1 of 1
I need Section Volumes
Posted:
Mon Mar 15, 2010 3:54 pmby techs
I am wondering is there a way to include volumes (yardage), to show up when I draw sections? I also wonder is there a way to change my label end areas to sqyds or is it a must for the sqft?
Posted:
Fri Apr 09, 2010 3:38 pmby site admin
Please send your question to
support@carlsonsw.com
thank you
Carlson Support
Posted:
Sun Apr 11, 2010 2:34 pmby grunyon11
I asked that question about a year or so ago, and I was told that they would add the section volumes in a future release. But, it evidentally didn't make it in the last release. As far as I know, there is no way to report the volumes on the cross sections.
Posted:
Mon Apr 12, 2010 12:30 pmby site admin
Yes, there are options for "Calculate Section Volumes" and "Calculate End Area". There are also options for cubic yards.
Posted:
Mon Apr 12, 2010 1:28 pmby grunyon11
As far as I can tell, there is no way of placing the volumes on the cross sections. I can label the end areas, but I cannot label volumes on the cross sections (unless I'm missing something).
Posted:
Mon Apr 12, 2010 2:19 pmby site admin
Try going to the Area/Layout menu and then Area Defaults. You can add the option to label Sq. Yds. and remove the Sq. Ft. from the list. Let us know if this is what you're looking for. Thank you