Design Pad Template problem
Posted: Thu Dec 23, 2010 7:07 pmI'm using Carlson 2011 build 101208 over IntelliCAD 6.6. When using the "Design Pad Template" function, it will get as far as creating the pad triangulation then stops.
1) The cursor in the viewport disappears, however the coordinate display at the bottom of the screen continues to function.
2) Buttons and menus still operate, but the functionality of them does not.
3) When attempting to close the program via the "x-button" it does not attempt to close, but says "cancel" in the command prompt display.
4) Windows Task Manager shows that the program is still "running", rather than "not responding".
I'm not sure what is wrong, but this is a function that I use quite often and it is quite frustrating for me. Any help with this is greatly appreciated. Thanks in advance!
1) The cursor in the viewport disappears, however the coordinate display at the bottom of the screen continues to function.
2) Buttons and menus still operate, but the functionality of them does not.
3) When attempting to close the program via the "x-button" it does not attempt to close, but says "cancel" in the command prompt display.
4) Windows Task Manager shows that the program is still "running", rather than "not responding".
I'm not sure what is wrong, but this is a function that I use quite often and it is quite frustrating for me. Any help with this is greatly appreciated. Thanks in advance!