by TLEng_sg » Wed Apr 20, 2011 8:21 am
Do it means that i will get the height reference of each section stored on the .sct section which i had cut along??
Am i right to say that, to create a new section:
1) Firstly, created a .tin file on the 3D plots,
2) After that i will draw a 2d polyline or a centerline along the 3d plot.
3) I will used the "input-edit section alignment" to create .mxs file using my .tin (mxs is to stored the location)
4) Used the "Sections from Grid or Triangualtion surface" to select a .tin, i was prompt to select a .mxs file after that i will have my .sct file created??
(sct file will store data for my cross section)
Please advise?? Thank you in advance..