Road Network
I need to create intersections in which the mainline (ML) edge of shoulder is STRAIGHT and ties to the approach road (AR) edge of shoulder (which should be offset per the template, ex. 2’) with no taper or change in width while tying in. Is this possible?
At this time, I can only create intersections in which the AR edge of shoulder is joined to the ML by a “tapered” radius. The edge of pavement is ok, but I need to eliminate the taper that comes with transitioning from an 8’ wide shoulder (ML) to a 2’ wide shoulder (AP). See Attached.
Any suggestions would be appreciated.