Utility Tunnel 3d modeling

Moderator: Carlson Support

Utility Tunnel 3d modeling

Postby monksjm » Fri Jul 11, 2014 7:02 pm

I'm tasked with creating a 3d model of a utility tunnel. The tunnel is about 500 feet long, 5 feet wide and about 8 feet high. I'm trying to figure out the best way to do this. I was thinking of trying to do a road network but wasn't sure if this is something i could do using Hydrology and creating a culvert type to run. Any suggestions? Thanks!
Shaun Morrison
Civil Designer/Drafter
Sevee & Maher Engineers, Inc.
Cumberland, Maine
monksjm
 
Posts: 110
Joined: Wed Jan 09, 2008 2:47 pm
Location: Cumberland, Maine

Re: Utility Tunnel 3d modeling

Postby tstrickland » Fri Jul 11, 2014 9:02 pm

Carlson has a lot of mining applications that would probably do what you are looking for, but I don't know anything about them.
Maybe there is a demo available that you could try and see.
Terry Strickland
tstrickland
 
Posts: 243
Joined: Thu Oct 25, 2007 6:39 pm

Re: Utility Tunnel 3d modeling

Postby monksjm » Mon Jul 14, 2014 4:44 pm

I'd be looking to do this with the civil suite package.
Shaun Morrison
Civil Designer/Drafter
Sevee & Maher Engineers, Inc.
Cumberland, Maine
monksjm
 
Posts: 110
Joined: Wed Jan 09, 2008 2:47 pm
Location: Cumberland, Maine

Re: Utility Tunnel 3d modeling

Postby Gibbo » Mon Jul 14, 2014 9:59 pm

What about F2F using the pipe setup option? Create points at bend points and using the diameter of the tunnel, you could create it with 3D faces? Is that suitable or are you trying to modelling an asbuilt of a tunnel?
Andy Gibson
Brisbane, Australia
Gibbo
 
Posts: 48
Joined: Thu Dec 29, 2011 9:42 am


Return to Civil

Who is online

Users browsing this forum: No registered users