Extend Command within 2DP
Posted: Wed Sep 08, 2021 6:31 pm
So I've run into a problem that I never had before this version (2021). I frequently use the Extend command nested inside the 2DP command, but if I try to turn an angle by bearing with it, it turns a different angle, and every time I've tried it I've also tried to figure out what angle it's turning, but no success.
If I exit out of the 2DP command and use Extender, everything works as expected, but that messes up my workflow.
Has anyone else encountered this or know how to fix it?
If I exit out of the 2DP command and use Extender, everything works as expected, but that messes up my workflow.
Has anyone else encountered this or know how to fix it?