Annotative scaling can be set up in Intelllicad. I experimented but did not like how it worked. You can create blocks for survey points that are annotative. At the time there were a lot of problems with edited scale lists getting reset an so on plus I felt Carlson created annotative entities with a scale difference of 1000 from how I expected it to work.
I gave up and have not looked at using annotative settings again. It may well work better now.
If you give it a go please report back here with how it worked out for you.
See Settings | Carlson Configure | General Settings:
2019-08-30 17_44_11-General Settings.png
and Points | Point Defaults:
2019-08-30 17_48_08-Point Defaults.png
You do not have the required permissions to view the files attached to this post.