pad with multiple elevations

Moderator: Carlson Support

pad with multiple elevations

Postby Matthew Timion » Wed Sep 18, 2002 11:42 pm

Hello all,

I am trying to create a polyline with multiple elevations within. For
example, the two north corners of a pad would be one elevation, and the
south two corners would be a second elevation. Is there a way to do this?
Do I have to create points and then connect the points to make a pad? Any
helps is appreciated!

Matt Timion
mtimion@dirtestimator.com
Matthew Timion
 

Re: pad with multiple elevations

Postby Nava Ran » Thu Sep 19, 2002 10:06 am

DTM-Contour Module->3Dpoly->Draw 3D Polyline
Prompt for elevations[Yes/<No>]?Y and Enter
Use surface model from file [Yes/<No>]?N and Enter
Pick point or point number and elevations as you want.

"Matthew Timion" <mtimion@dirtestimator.com> wrote
news:amakj7$bk5$1@update.carlsonsw.com...
Hello all,

I am trying to create a polyline with multiple elevations within. For
example, the two north corners of a pad would be one elevation, and the
south two corners would be a second elevation. Is there a way to do this?
Do I have to create points and then connect the points to make a pad? Any
helps is appreciated!

Matt Timion
mtimion@dirtestimator.com

Nava Ran
 

Re: pad with multiple elevations

Postby Matthew Timion » Thu Sep 19, 2002 9:21 pm

Thanks Nava! This is exactly what I was looking for... however, as soon as
I create the 3d polyline, it disappears. I'm sure that it's something
simple that I'm missing. Any ideas why it might be doing this?

Matt Timion
mtimion@dirtestimator.com


"Nava Ran" <navaran@zahav.net.il> wrote in message
news:ambliv$hdd$1@update.carlsonsw.com...
DTM-Contour Module->3Dpoly->Draw 3D Polyline
Prompt for elevations[Yes/<No>]?Y and Enter
Use surface model from file [Yes/<No>]?N and Enter
Pick point or point number and elevations as you want.
Matthew Timion
 

Re: pad with multiple elevations CORRECTION

Postby Matthew Timion » Thu Sep 19, 2002 9:37 pm

Ok, so after a little investigation, the 3d Polylines do appear, but they
show up very far away from the spot where I created them. Has anyone had a
similar problem with 3d polylines or points?

Matt Timion
mtimion@dirtestimator.com
Matthew Timion
 

Re: pad with multiple elevations CORRECTION

Postby R.K. McSwain » Fri Sep 20, 2002 3:46 am

Your UCS is not set to World. Most SurvCADD command require that the UCS be set to world.

To correct, enter the command UCS and press <Enter> twice, then enter the command PLAN and press <Enter> twice again.

"Matthew Timion" <mtimion@dirtestimator.com> wrote in message news:amd1jc$rvt$1@update.carlsonsw.com...
Ok, so after a little investigation, the 3d Polylines do appear, but they
show up very far away from the spot where I created them. Has anyone had a
similar problem with 3d polylines or points?

Matt Timion
mtimion@dirtestimator.com

R.K. McSwain
 


Return to Survey

Who is online

Users browsing this forum: Google [Bot], Majestic-12 [Bot]