Profile from points along centerline-suggestion

[Surveyor]

Would be nice if when using the create profile from points along centerline
(which I use alot for road projects), you could actually specify a point
numbers or point groups rather than having to draw the points 3D then pick
them one by one off the screen. JRL

[lwatson]

I will add this to our wishlist. In the meantime, just window all of the
points in the drawing and let the "Maximum Offset Tolerance" setting filter
out the unwanted points.

Lon


"Surveyor" <surveyor@yifan.net> wrote in message
news:dignm5$sdj$1@update.carlsonsw.com...

Would be nice if when using the create profile from points along
centerline (which I use alot for road projects), you could actually
specify a point numbers or point groups rather than having to draw the
points 3D then pick them one by one off the screen. JRL

[Surveyor]

Thanks, I'm able to get it done as you mentioned, just seemed backwards. Is
it using the elevation of the block insert for the profile, or is it going
to the CRD file? JRL


"Lon Watson" <lwatson@carlsonsw.com> wrote in message
news:dijkin$e2o$1@update.carlsonsw.com...

I will add this to our wishlist. In the meantime, just window all of the
points in the drawing and let the "Maximum Offset Tolerance" setting filter
out the unwanted points.

Lon


"Surveyor" <surveyor@yifan.net> wrote in message
news:dignm5$sdj$1@update.carlsonsw.com...
Would be nice if when using the create profile from points along
centerline (which I use alot for road projects), you could actually
specify a point numbers or point groups rather than having to draw the
points 3D then pick them one by one off the screen. JRL