On the section-profile menugroup, profiles->"input-edit profile file"
command, I am trying to input as-built information into the table. The
problem I have is that there is only one space for an elevation. Is there
any way to specify an in-elev and an out-elev? as is, it seems to only be
looking for a center elevation and that is not what I want. It seems odd
that there would not be a way to specify this because on the profile
report there are columns titled elev-in and elev-out and when the profile
file is drawn, an in and an out are drawn in. In both of these cases,
both the in and the out are the same as the single elevation I enter in
the input-edit profile file. Thanks to anyone who can shed some light on
this problem,
Matt
##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##