Inserting an Excel Spreadsheet

[Joe Bishop]

Hope you can help me. I am trying to insert an excel spreadsheet into a
drawing. I can get the spreadsheet in there, but not all of it shows up.
Also once its in there, I cannot move it or scale it. Any help would be
appreciated. I have a large project that I am trying to get out and I
really need to get this in there. Thanks in advance.

--
Bob Piggott
Joseph L. Bishop RLS, P.C.
31 Ottawa Drive
Pontiac, MI 48341-1631
(248) 334-2142 (248) 334-9341 Fax


Transfer of CADD/Electronic Files:
In accepting and utilizing any drawings, reports and data on any form of
electronic media generated and furnished by Joseph L. Bishop RLS, P.C., the
recipient agrees that all such electronic files are instruments of service
of Joseph L. Bishop RLS, P.C., who shall be deemed the author, and shall
retain all common law, statutory law and other rights, including copyrights.
The recipient also agrees not to transfer these electronic files to others
without the prior written consent of Joseph L. Bishop RLS, P.C.. Joseph L.
Bishop RLS, P.C. makes no warranties, either express or implies, of
merchantability and fitness for any particular purpose. In the event of a
conflict between the signed or sealed hard-copy document prepared by Joseph
L. Bishop RLS, P.C. and electronic files, the signed or sealed hard-copy
documents shall govern. In no event shall Joseph L. Bishop RLS, P.C. be
liable for indirect or consequential damages as a result of the recipient’s
use or reuse of the electronic files. Joseph L. Bishop RLS, P.C. shall be
held harmless against all damages, liabilities or costs, including
reasonable attorney fees and defense costs, arising out of or resulting from
use of these electronic files.

[TerryS]

There is one explanation on the following web site:

http://www.dotsoft.com/xl2cad.htm

Scoll down to the section "OLE has it's limitations, XL2CAD doesn't!"

What version of Autocad are you running?

In versions since Tables were introduced, I like to copy the selection in Excel, then type PASTESPEC in Autocad and Choose "Autocad Entities" as the type of paste. This brings in the information as an Autocad Table which is easy to alter and format. However, I have not tried this with a really large spreadsheet.