Moderator: Carlson Support
Was the "Group point entities" toggle ON before you located the
points?
to explain how it works:
If the "Group point entities" toggle is ON, then when you locate
points,
performs the additional task of placing the AutoCAD point entity, the
SurvCADD attribute block and the SurvCADD point symbol into an
anonymous
group. Whether they are all selected when you select a single entity
depends
on the status of the sysvar PICKSTYLE as mentioned earlier.
Also, the reactor that actually tells the CRD file to update (when
"Link
Points with CRD file" is ON) is attached to the AutoCAD point entity
of a
SurvCADD point. So even with "Link Points" toggled ON, if you fail to
move
the point entity, the CRD will not update.
Keep in mind that the "Link Points with CRD" option must be turned ON
*before* locating the points also.
If none of this helps any, post the drawing in the customer-files NG,
and
can take a look at it.
_________________________
Randall McSwain
Carlson Software
"Jason" <mlls@shentel.net> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59AE9B@WEBSERVER...
Everything is set correctly. Group toggle is on. I hit Ctrl-A as
check,
was ON. PICKSTYLE is set to 1. It is still not moving all 3 entities
that
pertain to the point.
Jason
"Randall McSwain" <rmcswain@carlsonsw.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59AE8E@WEBSERVER...
Jason, make sure AutoCAD 'Group' mode is toggled
ON. Ctrl-A is the shortcut to toggle group mode on
and off. Group mode is controlled by the AutoCAD
system variable PICKSTYLE. A setting of 1 or 3
enables group mode.
Randall McSwain
Carlson Software
"Jason" <mlls@shentel.net> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59AE78@WEBSERVE
R...
It doesn't appear that the configure
survcadd--general settings--object
linking--group point entities is working
correctly. I believe the command is
supposed to select all Survcadd entities when I
select any part of a point.
I had the boxed checked, along with the link
points to CRD file, then tried
to use the Autocad move command. I selected the
point number only and also
tried the symbol only, neither moved any other
part of the point along with
it and the coordinate never changed. Yes, I know
there is a Survcadd move
point command that does move the points
correctly.
Jason Bly
I change "break contour at label insertion" so that it is UN-checked
in
configure survcad.. but I open a drawing and it reverts to breaking
them..
why? can I change this setting with in a lisp or dcl file or some
file...
it never turns itself back on... please I beg of you guys at survcad
to
me with this....
--
Jonathan Baker
R&R Engineers-Surveyors, Inc.
Denver, Colorado 80246
http://www.rrengineers.com/
Phone: 303-753-6730 ext 15
________________________
I can't backspace to correct numbers when entering a point rangein
CES.
I try to backspace it does not erase the previous number and sometimes
appends more numbers on to the end. I had the same problem with SC2000
as
well.
Jason
Users browsing this forum: No registered users