Carlson Software Forum

Is there a centerline file (.CL) report command?

I want to check that it converted the polyline correctly and correct
direction.

Jason

Section-Profile Module
Design Menu
5th item down - Centerline Report

"Jason" <jbly@marshandlegge.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59010873@WEBSERVER...

Is there a centerline file (.CL) report command?

I want to check that it converted the polyline correctly and correct
direction.

Jason

Thanks. It doesn't make sense to have the polyline to CL file in Cogo
group,
then have to switch modules to get the report.

Maybe you should think about making a report pulldown (like Inq-set and
Points) that has various types of reports the user may want. There would
no
questioning as to what information this menu would contain and
centeralize
all the report commands.

List points
Lot file report
CL report
calculate offsets
polyline report
etc.

"Randall McSwain" <rmcswain@carlsonsw.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59010876@WEBSERVER...

Section-Profile Module
Design Menu
5th item down - Centerline Report

"Jason" <jbly@marshandlegge.com> wrote in message
news:B4A0F73FCE8FD411AF8B00207811DE59010873@WEBSERVER...
Is there a centerline file (.CL) report command?

I want to check that it converted the polyline correctly and correct
direction.

Jason