Map check Re-Request
Posted: Mon Dec 17, 2001 11:05 pm
We have requested this before and were told by Bruce Carlson that it would
be added to a next build, but we haven't seen it yet....
Under the Enter Deed Description program, we need to be able to enter radial
bearings for non-tangent curves instead of the default Chord bearing input.
Please program an option to do this.
Not being able to do this has caused us to keep our old C&G DOS program on
our stations in order to perform true mapchecks. In this part of the
country, we show radial bearings on our plats and boundary surveys and have
to be able to show that inputted data on our printed lot calculations
submitted to the municipalities.
If we had this capability in SurvCAD CES, it would save a b---load of time
finding "fatfingered" mistakes while performing mapchecks since our DOS
mapcheck program does not have graphic capabilities included.
Please let us know when we can expect this capability. We'd rather not have
to by a third program to gain graphic capability in this process!
be added to a next build, but we haven't seen it yet....
Under the Enter Deed Description program, we need to be able to enter radial
bearings for non-tangent curves instead of the default Chord bearing input.
Please program an option to do this.
Not being able to do this has caused us to keep our old C&G DOS program on
our stations in order to perform true mapchecks. In this part of the
country, we show radial bearings on our plats and boundary surveys and have
to be able to show that inputted data on our printed lot calculations
submitted to the municipalities.
If we had this capability in SurvCAD CES, it would save a b---load of time
finding "fatfingered" mistakes while performing mapchecks since our DOS
mapcheck program does not have graphic capabilities included.
Please let us know when we can expect this capability. We'd rather not have
to by a third program to gain graphic capability in this process!