ces BUGS

[massimiliano ferrari]

May be useful to let everybody knows.....

I have been experiencing the following anomalies with SurvCadd CES
(10/23/2001 built) and not on a single project:

- Hatch zones in Strata Isopach Maps doesn't work properly if exclusion
areas are used (the hatching doesn't actually follow the contour zone you
specify in the hatch zone dialog). With survcadd 2000 the problem is even
worst, in the majority of the cases I couldn't hatch zones at all even when
only the inclusion perimeter was selected.

- Tag drillhole for processing doesn't work at all. It locks up the
application and when you try to escape the command you receive the message
on the command line that says "could not match layer". The same files were
handled perfectly on SurvCadd 2000

- Mark compliance drillholes doesn't work at all and does the same thing
than Tag drillhole for processing. The same files were handled perfectly on
SurvCadd 2000. It looks that those problems are somehow related ......


following are oldies......

- compliance area from grids doesn't work properly if at all

- design bench pit works only from the bottom up... and that's a real pit..y

- Coordinate transformation with map5 doesn't use all the coordinate system
available on map 5

hoping that the next release will fix the above specified.......

best regards

Massimiliano Ferrari