Carlson Software Discussion Group
http://update3.carlsonsw.com/forum/
Posted: Sat Jan 05, 2002 5:35 amPosted: Tue Jan 08, 2002 10:32 pmWhy does the move points command only allow you to move 1 point at a time?
Could this routine be updated to allow multiple point selection?
Geoff
Posted: Wed Jan 09, 2002 7:18 pmWhy does the move points command only allow you to move 1 point at a
time?
Could this routine be updated to allow multiple point selection?
Geoff
Posted: Wed Jan 09, 2002 7:28 pm
Yes it does, but this routine forces you to select a range of point
values. However, if you just want to select multiple points visually
you cannot use this routine. Could this be added to suggestions for
the next release?
"R.K. McSwain" <rmcswain@carlsonsw.com> wrote in message
news:74FEE5B80AD9D511A49800207811DE544711@24-216-164-75.hsacorp.net...
"Translate Points" allows you to move multiple points.
"Geoffrey Leiter" <darc87@hormail.com> wrote in message
news:74FEE5B80AD9D511A49800207811DE5446EF@24-216-164-75.hsacorp.net...
Why does the move points command only allow you to move 1 point at a
time?
Could this routine be updated to allow multiple point selection?
Geoff