Custom Toolbars

[Jack Goodrich]

I have recently installed the DTM module. I made some customized toolbars
from the COGO menu which now cannot be retrieved when the DTM menus are
loaded. I realize that I should have attached the customized toolbars to the
SCAD menu, so they would always appear. I need these toolbars in DTM. Is
there any way I can change the attachment of the custom toolbars from the
COGO menu to the SCAD menu?

Thanks,
Jack

[R.K. McSwain]

You will have to open the .MNS files and cut/paste the appropriate section(s) from one menu to the other.

--
Randall McSwain
Carlson Software
http://www.carlsonsw.com

"Jack Goodrich" <jwg@sec-civil.com> wrote in message news:74FEE5B80AD9D511A49800207811DE544EA6@24-216-164-75.hsacorp.net...

I have recently installed the DTM module. I made some customized toolbars
from the COGO menu which now cannot be retrieved when the DTM menus are
loaded. I realize that I should have attached the customized toolbars to the
SCAD menu, so they would always appear. I need these toolbars in DTM. Is
there any way I can change the attachment of the custom toolbars from the
COGO menu to the SCAD menu?

Thanks,
Jack

[Jack Goodrich]

Many thanks Randall!! That was so easy to do. I got depressed thinking I was
going to have to go through that lengthy process of creating custom toolbars
again.