Page 1 of 1

Select Nodes

PostPosted: Mon Jul 01, 2002 7:47 pm
by Geoffrey Leiter
I would like to select nodes with a particular descriptor in a selectable
area. Is this possible? I see options to do one or the other but not both.

Geoff

Re: Select Nodes

PostPosted: Thu Jul 11, 2002 8:44 pm
by Geoffrey Leiter
Anyone here???

"Geoffrey Leiter" <darc87@hotmail.com> wrote in message
news:afpt7i$9p0$1@update.carlsonsw.com...
I would like to select nodes with a particular descriptor in a selectable
area. Is this possible? I see options to do one or the other but not
both.

Geoff


Re: Select Nodes

PostPosted: Fri Jul 12, 2002 5:02 pm
by R.K. McSwain
Geoffrey,

You are correct, there is no way to do both using List Points. You *can* do this in Draw-Locate Points. So you could open an new empty drawing, import your polyline boundary, then use Draw-Locate Points and only draw the points that matched the description within the polyline boundary.

------------------
Randall McSwain
Carlson Software


"Geoffrey Leiter" <darc87@hotmail.com> wrote in message news:afpt7i$9p0$1@update.carlsonsw.com...
I would like to select nodes with a particular descriptor in a selectable
area. Is this possible? I see options to do one or the other but not both.

Geoff