Carlson Software Forum

Hello all,

I seem to be having a problem with the OFFSET3D Command. I am working on
pads and am trying to offset the polylines by .1 feet. When it asks me what
side I would like to offset the polyline on, I click on the inside of the
pad. The offset, however, is ALWAYS made on the outside of the pad. Has
this happened to anyone else? Any idea how to fix it?

Thanks,

Matt Timion
mtimion@dirtestimator.com

Do you have any osnaps on that might be trying to "grab" something outside
of your polyline? If so, hit F3 to turn it off all osnaps and try again.

"Matthew Timion" <mtimion@dirtestimator.com> wrote in message
news:am838r$om3$1@update.carlsonsw.com...

Hello all,

I seem to be having a problem with the OFFSET3D Command. I am working on
pads and am trying to offset the polylines by .1 feet. When it asks me
what
side I would like to offset the polyline on, I click on the inside of the
pad. The offset, however, is ALWAYS made on the outside of the pad. Has
this happened to anyone else? Any idea how to fix it?

Thanks,

Matt Timion
mtimion@dirtestimator.com