Carlson Software Forum

Posted: **Sat Mar 08, 2003 2:44 am**

I've never noticed Survcadd doing this before, but when updating CRD from
drawing it's trying to update each point selected twice. It appears to be
trying to make a point from the attributes and the point mark. I know I can
tell it to Overwrite all without prompting, but I do not like to do that
because I don't want to overwrite data by accident.

Has anyone else found this error?

I even tried exiting Autocad and reopening the drawing and it still does it.

Jason

Posted: **Sat Mar 08, 2003 2:44 am**

Same thing happening here with me,,, I am glad you posted and I look forward
to a reply.
"Jason Bly" <jbly@marshandlegge.com> wrote in message
news:b4b3sb$bgr$1@update.carlsonsw.com...

I've never noticed Survcadd doing this before, but when updating CRD from
drawing it's trying to update each point selected twice. It appears to be
trying to make a point from the attributes and the point mark. I know I
can
tell it to Overwrite all without prompting, but I do not like to do that
because I don't want to overwrite data by accident.

Has anyone else found this error?

I even tried exiting Autocad and reopening the drawing and it still does
it.

Jason

Posted: **Sat Mar 08, 2003 3:27 am**

here too..

"Joseph Bishop" <jlbsurvey@ameritech.net> wrote in message
news:b4b42f$bhp$1@update.carlsonsw.com...

Same thing happening here with me,,, I am glad you posted and I look
forward
to a reply.
"Jason Bly" <jbly@marshandlegge.com> wrote in message
news:b4b3sb$bgr$1@update.carlsonsw.com...
I've never noticed Survcadd doing this before, but when updating CRD
from
drawing it's trying to update each point selected twice. It appears to
be
trying to make a point from the attributes and the point mark. I know I
can
tell it to Overwrite all without prompting, but I do not like to do that
because I don't want to overwrite data by accident.

Has anyone else found this error?

I even tried exiting Autocad and reopening the drawing and it still does
it.

Jason

Posted: **Wed Feb 25, 2009 4:23 pm**

First you have to isolate only the points attributes with no point marks. This is beacuse if you use this routine with the marks on it will select, after reading the attributes info, the point marks and will ask you to overwrite the points already selected with the marks that have no attribue information. Hope this help you all.

Carlson Software Forum

Update CRD file from drawing

Update CRD file from drawing

Re: Update CRD file from drawing

Re: Update CRD file from drawing

Update CRD file from drawing