Carlson Software Forum

Is there a way to label the distance and slope on a plan view of a 3d
Polyline? I'm doing asbuilts for City review and they want to see pipe
(storm and sanitary) distances labeled with there slope percent. I was
hoping that I could just draw a 3d polyline from point to point, then click
on the line to have it labeled.

Any ideas?

Jason

Profiles | Polyline Slope Report?


"Jason Bly" <jbly@marshandlegge.com> wrote

Is there a way to label the distance and slope on a plan view of a 3d
Polyline?

That is for clicking on a line within a profile grid and getting the slope.
It asks for the horizontal and vertical scale in the dialog box.

I'm not sure there is a routine that does what I want.

Jason

"R.K. McSwain" <rkmcswain@yahoo.com> wrote in message
news:b4tbn0$q5p$1@update.carlsonsw.com...
Profiles | Polyline Slope Report?


"Jason Bly" <jbly@marshandlegge.com> wrote

Is there a way to label the distance and slope on a plan view of a 3d
Polyline?

You are right, I didn't read your post correctly. What about ToolPac, I'm sure it's in there.

"Jason Bly" <jbly@marshandlegge.com> wrote in message news:b4tic0$s0m$1@update.carlsonsw.com...

That is for clicking on a line within a profile grid and getting the slope.
It asks for the horizontal and vertical scale in the dialog box.

Send the 3d polylines and I will send back the polylines with annotations as
you need.

Nava Ran
-----------
Automatic Mapping Solutions

"Jason Bly" <jbly@marshandlegge.com>
news:b4tadq$pou$1@update.carlsonsw.com...

Is there a way to label the distance and slope on a plan view of a 3d
Polyline? I'm doing asbuilts for City review and they want to see pipe
(storm and sanitary) distances labeled with there slope percent. I was
hoping that I could just draw a 3d polyline from point to point, then
click
on the line to have it labeled.

Any ideas?

Jason

Anybody know how to do what the OP asked?
The Polyline Slope Report command (llg) is really inaccurate for normal lines and polylines in model space.

I'd like to think that in twenty years, they've found a solution for this...

THEY DID IT IN (at least) 2019!
label3dp
Here's the manual link: https://files.carlsonsw.com/mirror/manu ... gment.html