Anyone experienced with metric DTM conversions?
Posted:
Wed May 14, 2003 2:17 amby RMM
Hello all,
Anyone care to share their experience with converting a terrain model from
metric to english? I don't see a way to do this except for the long and
tedious task of creating new points from entities, use the scale points
command and then redraw the TIN "by hand". Any ideas?
Thanks, and a great ng, btw.
RMM
Re: Anyone experienced with metric DTM conversions?
Posted:
Wed May 14, 2003 2:20 amby dcjohnson
turn it into a block then you can scale the Z leaving the X and Y alone. then
eplode it.
--
Dave C. Johnson
djohnson@wwcengineering.comWWC Engineering
Sheridan WY.
Windows 2k2
Acad Map 5
Survcadd XML
Re: Anyone experienced with metric DTM conversions?
Posted:
Wed May 14, 2003 2:46 amby RMM
"dcjohnson" <djohnsonout@outwwcengineering.com> wrote in message
news:3EC16FB0.7050502@outwwcengineering.com...
turn it into a block then you can scale the Z leaving the X and Y alone.
then
eplode it.
--
Dave C. Johnson
djohnson@wwcengineering.comWWC Engineering
Sheridan WY.
Windows 2k2
Acad Map 5
Survcadd XML
That worked really well. Thanks very much, Dave.
RMM
Re: Anyone experienced with metric DTM conversions?
Posted:
Wed May 14, 2003 3:45 amby R.K. McSwain
ToolPac also includes an independent XYZ scale command
"dcjohnson" <djohnsonout@outwwcengineering.com> wrote
turn it into a block then you can scale the Z leaving the X and Y alone.
then
eplode it.