Carlson Software Forum

Is there anyway to import points from the lot file? We have a new drawing
attached to an existing crd and lot file and want to import the points
associated with the lots because the point number vary in range.

Thanks for any help.

Reed Adams

If the new drawing is attached is the existing CRD file, then all you are
really trying to do is get the lot corner point symbols into the new
drawing. If so, then most likely you have the lot corner symbols on its own
layer, so just block out that layer/symbols from the old drawing and insert
them into the new drawing.

Jason

"E. R. Adams" <eradams@dewberry.com> wrote in message
news:bhfv73$j79$1@update.carlsonsw.com...

Is there anyway to import points from the lot file? We have a new drawing
attached to an existing crd and lot file and want to import the points
associated with the lots because the point number vary in range.

Thanks for any help.

Reed Adams