Carlson Software Forum

We just got our first seat of xml2 installed so we can test it for any bugs.
I have a problem when using the configure Survcadd command. The problem is
that when I pick the DTM-Contour module option in Survcadd Config the
computer locks up completely. Has any one else had this problem?

The machine it is on is a p4 2gig with 512 meg of ram.

thx,
Dan Grubb

"Dan Grubb" <dangrubb@zande.com> wrote in message
news:bidgn1$2cj$1@update.carlsonsw.com...

We just got our first seat of xml2 installed so we can test it for any
bugs.
I have a problem when using the configure Survcadd command. The problem is
that when I pick the DTM-Contour module option in Survcadd Config the
computer locks up completely. Has any one else had this problem?

The machine it is on is a p4 2gig with 512 meg of ram.

thx,
Dan Grubb

Now that you mention it, it most certainly does!

I have had another couple of lockups too. I have not documented them all.
I am waiting for repeats.

One that is reproducable is:

While in the INPUT/EDIT PROFILES dialog, I entered a vertical curve
length that was too big. A warning dialog appeared that could not be
satisfied, thus locking up the session.

Terry Scanlon