Carlson Software Forum

I have a few questions as a new user of Carlson Software.

1. Is it possible to create (draw) 3d faces from an existing FLT file from a
previous session?
2. Is it possible to edit 3d faces in a drawing, then just update its FLT
file?
3. Is it possible to use an existing FLT when prompted for selection in the
"triangulate and contour" command?

Thanks in advance.
Stephen

"Stephen Rhodes" <stephen.rhodes@fyfe.com.au> wrote

1. Is it possible to create (draw) 3d faces from an
existing FLT file from a
previous session?

DTM | Contour | Draw Triangular Mesh

3. Is it possible to use an existing FLT when prompted for
selection in the
"triangulate and contour" command?

On the selection tab in the Contour dialog, check the toggle
for "3D Faces"