duplicate lines created using 3dintersect
Posted: Tue Sep 02, 2003 7:55 pmI've recently been turned on to the command "3dintersect." I've used it
more often than I'd like to admit lately, but admittedly, I'd use it even
more often if it did not create duplicate lines. For example:
If I am elevating a TC off of a Center Line at -2%, it will create a new CL
and a new TC. The new CL is a clone of the old one, and the new TC is the
same as the old TC, but it is elevated.
I am not sure if there is a way to have this command only convert existing
lines and not create new ones, but if there is, I'd love to hear about it.
--
Matt Timion
Earthwork Calculation Services
more often than I'd like to admit lately, but admittedly, I'd use it even
more often if it did not create duplicate lines. For example:
If I am elevating a TC off of a Center Line at -2%, it will create a new CL
and a new TC. The new CL is a clone of the old one, and the new TC is the
same as the old TC, but it is elevated.
I am not sure if there is a way to have this command only convert existing
lines and not create new ones, but if there is, I'd love to hear about it.
--
Matt Timion
Earthwork Calculation Services