Translate points by elevation

Hello all,
I'm looking for a way to translate only certain points in my CRD file based
on their elevation.
My leader texts are truncated at two digits, so what should be a "100"
elevation is actually "00". This becomes a problem when "99" is right next
to "00".
Is there a way to conditionally change Z values of points in a CRD file
based on an elevation range? (In this case, I'd raise anything between 00 to
40 one hundred feet.
--
Matt Timion
Earthwork Calculation Services
I'm looking for a way to translate only certain points in my CRD file based
on their elevation.
My leader texts are truncated at two digits, so what should be a "100"
elevation is actually "00". This becomes a problem when "99" is right next
to "00".
Is there a way to conditionally change Z values of points in a CRD file
based on an elevation range? (In this case, I'd raise anything between 00 to
40 one hundred feet.
--
Matt Timion
Earthwork Calculation Services