Carlson Software Forum

Hello group.

When designing SWM ponds it is neccessary that we get soil borings in the
vicinity of the pond. From the borings we need to create a subsurface map
that will affect our pond design. Looking through the SurvCADD help file it
would appear the only way to accomplish this feat would be by purchasing the
Mining or Advanced Mining modules. Subsurface analysis is a common
engineering practice and it would seem that what we are trying to accomplish
should be an option in the DTM & Contour Module. Any input or suggestions
from the group or Carlson would be appreciated.

James Shaw
G.W. Stephens, Jr. and Associates, Inc.

just make three surface your existing, proposed, and your rock "subsurface"
use 2 surface comparison and just compare your proposed to the existing and
then to the rock
"James Shaw" <jshaw@-nospam-gwstephens.com> wrote in message
news:bogbo6$m2a$1@update.carlsonsw.com...

Hello group.

When designing SWM ponds it is neccessary that we get soil borings in the
vicinity of the pond. From the borings we need to create a subsurface map
that will affect our pond design. Looking through the SurvCADD help file
it
would appear the only way to accomplish this feat would be by purchasing
the
Mining or Advanced Mining modules. Subsurface analysis is a common
engineering practice and it would seem that what we are trying to
accomplish
should be an option in the DTM & Contour Module. Any input or suggestions
from the group or Carlson would be appreciated.

James Shaw
G.W. Stephens, Jr. and Associates, Inc.