Carlson Software Discussion Group
http://update3.carlsonsw.com/forum/
Posted: Mon Dec 22, 2003 8:55 pmPosted: Mon Dec 22, 2003 8:56 pmI have received a set of drawings from a client. When we try to draw-locate
points on the drawing the point is displayed somewhere off into space. the
descriptors stay in the right place but the point is in the wrong place.
Posted: Mon Dec 22, 2003 9:23 pmI have received a set of drawings from a client. When we try to
draw-locate
points on the drawing the point is displayed somewhere off into space. the
descriptors stay in the right place but the point is in the wrong place.
Posted: Fri Jun 11, 2004 2:56 am
no, we tried that too thinking that was the problem but it didn't fix it.
"R.K. McSwain" <rkmcswain@yahoo.com> wrote in message
news:bs743o$lmc$1@update.carlsonsw.com...
Is the UCS set to something other than World?
"Gwen Harp" <gharp@wainc.biz> wrote in message
news:bs73dg$l9l$1@update.carlsonsw.com...
I have received a set of drawings from a client. When we try to
draw-locate
points on the drawing the point is displayed somewhere off into space.
the
descriptors stay in the right place but the point is in the wrong place.