Carlson Software Forum

I haven't noticed this in all drawings, but the units keep resetting to
scientific. I can change it to decimal then within a few commands it will be
back to scientific. First off, I don't know anyone that uses scientific
units. I'm not sure if there is something in Survcadd that resets that
variable to scientific. Has anyone else experienced this?

Jason

"Jason Bly" <jbly@marshandlegge.com> wrote in message news:cd785v$ooq$1@update.carlsonsw.com...

I haven't noticed this in all drawings, but the units keep resetting to
scientific. I can change it to decimal then within a few commands it will be
back to scientific. First off, I don't know anyone that uses scientific
units. I'm not sure if there is something in Survcadd that resets that
variable to scientific. Has anyone else experienced this?

No solution, but maybe some leads....

http://tinyurl.com/5sr5v

http://tinyurl.com/4pbj5