Carlson Software Forum

When I try to list points, I get a "SurvCADD Message" stating "Can't open
output file". I reset my CRD and it recognizes the points, but I can't list
them. Thanks for the help.

Check and see if for some reason the SurvCADD\User folder has been set to
"read only". If so reset the write permission by clearing the read only
setting.


"Brick Linder" <brickt@ptd.net> wrote in message
news:d1c8go$8t5$1@update.carlsonsw.com...

When I try to list points, I get a "SurvCADD Message" stating "Can't open
output file". I reset my CRD and it recognizes the points, but I can't
list them. Thanks for the help.

Try closing down Autocad and reopening everything. I've had cases where it
thinks someone else has a CRD file open, when it was actually me that had it
open. If just closing Autocad doesn't work, then reboot computer just to
make sure.

It's worth a shot.
Jason

"Brick Linder" <brickt@ptd.net> wrote in message
news:d1c8go$8t5$1@update.carlsonsw.com...

When I try to list points, I get a "SurvCADD Message" stating "Can't open
output file". I reset my CRD and it recognizes the points, but I can't
list
them. Thanks for the help.