Carlson Software Forum

I just upgraded to AutoCAD 2006 with SurvCadd 2006 from 2002/XML. The
inverse command now seems to have a significant lag. The system pauses
for
about 2 seconds after each click. It only seems to happen when picking
points off the screen. If I enter point numbers its fine. Has anyone else
experienced this problem? I'm running a P4/3.4, 1G ram, 128MB ATI video
card.

Any help would be greatly appreciated.

Thanks

Jason

Hey Jason;

Did your upgrade to 2K6 include the recent service pack? If you acquired
2K6 awhile back, then you probably want to see where you can get the SP I
would imagine:
http://tinyurl.com/pgof

That "might" help the issue you reported also.

--
Don Reichle
"King Of Work-Arounds"
"The only thing worse
than training your staff,
and having them leave is -
not training your staff,
and having them stay."
Courtesy Graphics Solution Providers
--------------------------------------
LDT-2K4
AMD64 3200+
XPPro 32bit SP2
1GB RAM
Nvidia GeForce FX 5200 128MB
Western Digital Raptor 10K-rpm HD


"Jason" <jasonedwards@optonline.com> wrote in message
news:di0kuc$cf0$1@update.carlsonsw.com...
I just upgraded to AutoCAD 2006 with SurvCadd 2006 from 2002/XML. The
inverse command now seems to have a significant lag. The system pauses
for
about 2 seconds after each click. It only seems to happen when picking
points off the screen. If I enter point numbers its fine. Has anyone else
experienced this problem? I'm running a P4/3.4, 1G ram, 128MB ATI video
card.

Any help would be greatly appreciated.

Thanks

Jason

Hey Don,

Thanks for the response. I have installed all the SPs'. I've been doing
some experimenting and it seems that it has something to do with crd file
being on a network share. If I move the crd to my local drive the problem
disapears. A network problem I guess. Its strange to me that this problem
did not exist in previous releases. What has changed?

Any further suggestions would be great

Thanks

Jason

"Don Reichle" <spamless-reichle4@hotmail.com> wrote in message
news:di14at$oev$1@update.carlsonsw.com...
Hey Jason;

Did your upgrade to 2K6 include the recent service pack? If you acquired
2K6 awhile back, then you probably want to see where you can get the SP I
would imagine:
http://tinyurl.com/pgof

That "might" help the issue you reported also.

--
Don Reichle
"King Of Work-Arounds"
"The only thing worse
than training your staff,
and having them leave is -
not training your staff,
and having them stay."
Courtesy Graphics Solution Providers
--------------------------------------
LDT-2K4
AMD64 3200+
XPPro 32bit SP2
1GB RAM
Nvidia GeForce FX 5200 128MB
Western Digital Raptor 10K-rpm HD


"Jason" <jasonedwards@optonline.com> wrote in message
news:di0kuc$cf0$1@update.carlsonsw.com...
I just upgraded to AutoCAD 2006 with SurvCadd 2006 from 2002/XML. The
inverse command now seems to have a significant lag. The system pauses
for
about 2 seconds after each click. It only seems to happen when picking
points off the screen. If I enter point numbers its fine. Has anyone
else
experienced this problem? I'm running a P4/3.4, 1G ram, 128MB ATI video
card.

Any help would be greatly appreciated.

Thanks

Jason