Carlson Software Forum

I'm blocking out a drawing, (linework and points) I'm selecting 0,0 as the
insertion point, but when I insert it to a new drawing, at 0,0 it doesn't
come in on the same coordinate. Why?



##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

briburr said the following on 3/15/2006 7:36 AM:

I'm blocking out a drawing, (linework and points) I'm selecting 0,0 as the
insertion point, but when I insert it to a new drawing, at 0,0 it doesn't
come in on the same coordinate. Why?

Is UCS set to world in both drawings?
Is BASE set to 0,0,0 in both drawings?

--
R.K. McSwain
http://rkmcswain.blogspot.com

"briburr" <briburr88@hotmail.com> wrote in message
news:dv958u$7mc$1@update.carlsonsw.com...

I'm blocking out a drawing, (linework and points) I'm selecting 0,0 as the
insertion point, but when I insert it to a new drawing, at 0,0 it doesn't
come in on the same coordinate. Why?

In addition to Mr. McSwain's suggestions, check your UNITS settings and make
sure the "Drag-and-drop scale" are the same in both drawings .