Carlson Software Forum

All of a sudden when I draw a curve arrow, the arrowhead appears but no
leader... This happens in just one drawing in model space. In paper
space I have no problems. In other drawings I have no problems. What's
the deal??? I changed no settings and previously had no problems drawing
curve arrows in this drawing.


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

Hey what do you know...I answered my own question...UCS got switched to
something else, I was in negative coords...my arrow appeared where it
should, but the leader was drawn 10000 feet away in positive coords.
Switched UCS back to World and all is OK. How this stuff happens and UCS
decides to change by itself is beyond comprehension...




Nathan wrote:

All of a sudden when I draw a curve arrow, the arrowhead appears but no
leader... This happens in just one drawing in model space. In paper
space I have no problems. In other drawings I have no problems.
What's
the deal??? I changed no settings and previously had no problems
drawing
curve arrows in this drawing.

##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

Nathan said the following on 6/15/2006 8:11 AM:

How ... UCS
decides to change by itself is beyond comprehension...

LOL... That's because it doesn't. Something is changing it...

--
R.K. McSwain
http://rkmcswain.blogspot.com