Carlson Software Forum

When trying to draw a proposed pipe profile using Carlson Civil 2007 the
program does not plot the horizontal or slope distance of the pipe. The
routine stops after drawing invert elevations, the grid and the pipe. Has
anyone encountered a similar problem?


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

jsehl wrote:

When trying to draw a proposed pipe profile using Carlson Civil 2007
the
program does not plot the horizontal or slope distance of the pipe. The
routine stops after drawing invert elevations, the grid and the pipe.
Has
anyone encountered a similar problem?

##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

to jsehl,
You might try to rotate your profile working space so that north is up
(twist screen to due north). Hope this helps, Tom





##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##