Carlson Software Forum

I have been trying to generate a curve table using the Curve Table command
under Annotate. Unfortunately, after I select the arc, assign a number,
and select the table location, the following error shows up:

bad argument type: stringp 0.228544 :error#0

Line tables generate just fine, and curve tables work fine on the other
SurvCADD 2006 equipped computers in our office. I have tried it multiple
times on different files, even files that we have generated curve tables
successfully on before, so I know that it isn't the file. Anybody have any
ideas?

Thanks,
Ben L.


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##

Short of reinstalling Survcadd, I would make sure you have all the latest
patches...otherwise, sounds like contacting technical support is called for
for such an issue.


"Ben L." <benl@lewicki.biz> wrote in message
news:ev3ucf$ai4$1@update.carlsonsw.com...

I have been trying to generate a curve table using the Curve Table command
under Annotate. Unfortunately, after I select the arc, assign a number,
and select the table location, the following error shows up:

bad argument type: stringp 0.228544 :error#0

Line tables generate just fine, and curve tables work fine on the other
SurvCADD 2006 equipped computers in our office. I have tried it multiple
times on different files, even files that we have generated curve tables
successfully on before, so I know that it isn't the file. Anybody have any
ideas?

Thanks,
Ben L.


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.survcadd
##-----------------------------------------------##