Carlson Software Forum

Posted: **Thu Jan 24, 2008 7:21 pm**

i am using a digitizer and the plans that i am trying to digitize are too big. does anyone know if there is a way to digitize the whole drawing

Posted: **Fri Jan 25, 2008 8:31 pm**

You can digitize multiple sheets as long as they have 2 common points you can click on the 1st before removing it and then on the 2nd to recalibrate to the new sheet.

Posted: **Mon Jan 28, 2008 9:36 pm**

ok do i use one of my original reference points and then create a new one or do i just make a whole new set of reference points?

Posted: **Tue Jan 29, 2008 2:53 pm**

Either way. If your reference points you used the first time can be found on the second sheet then its a little easier but not a necessity. If they cannot then simply make 2 new ones on your first page that you can find on the second before you remove the first from digitizer.

Posted: **Mon Feb 04, 2008 7:12 pm**

ok thanks a lot i finally got it. and i also figured out what i was doing wrong. thanks for the help