Page 1 of 1
creating 3d fault lines
Posted:
Fri Feb 15, 2008 1:31 amby jhamm
Why do I get some 3d fault lines at their appropriate elevations and some at zero elevation? I use a specific Code file designed to recognize hard breaklines. For example a 'face of curb' line may have elevations but the 'back of curb' line will be at '0'.
Posted:
Fri Feb 15, 2008 4:32 pmby Jason
Make sure you have the entity to draw to 3dpoly. Other than this, I'd probably just have to see the files.
Posted:
Sat Feb 16, 2008 1:18 amby jhamm
The 3dpoly is set for all the codes. Would the .dwg & .fld files be sufficient? How can these files be attached?
We are off Monday and I appreciate your help
Posted:
Mon Feb 18, 2008 2:37 pmby Jason