UCS> View Problems
Posted: Wed Mar 11, 2009 3:02 pmUCS>View command does not work...
I don't like the reset cross hairs command because there is no way to reset the crosshairs to a world coordinate system after the crosshairs have been reset. The only way I can figure out how to do this is to reset DVIEW to 0 and then reset the crosshairs again...
It would be much easier to simply set my UCS to view...
Anyone have a better way of doing this?
-Eric
I don't like the reset cross hairs command because there is no way to reset the crosshairs to a world coordinate system after the crosshairs have been reset. The only way I can figure out how to do this is to reset DVIEW to 0 and then reset the crosshairs again...
It would be much easier to simply set my UCS to view...
Anyone have a better way of doing this?
-Eric