When we use ANNOTATE /LINE TABLE and selection by point and enter the point number
Message is displayed COORD FILE NOT SET but we have made sure it is set.
When I run this command in Autocad Civil 2008 and Standalone Survey 2006 it works.
ANNOTATE LINE TABLE
Moderator: Carlson Support
4 posts
• Page 1 of 1
ANNOTATE LINE TABLE
by cfm » Fri Mar 27, 2009 5:47 am
Just a little bug we have discovered in Autocad Civil 2009 and Intellicad Civil 2009
When we use ANNOTATE /LINE TABLE and selection by point and enter the point number
Message is displayed COORD FILE NOT SET but we have made sure it is set.
When I run this command in Autocad Civil 2008 and Standalone Survey 2006 it works.
When we use ANNOTATE /LINE TABLE and selection by point and enter the point number
Message is displayed COORD FILE NOT SET but we have made sure it is set.
When I run this command in Autocad Civil 2008 and Standalone Survey 2006 it works.
- cfm
- Posts: 22
- Joined: Wed Mar 11, 2009 10:06 pm
- Location: Townsville, Queensland, Australia
by site admin » Tue Mar 31, 2009 4:53 pm
This has been fixed and will be available in the next build. Thanks for the report.
- site admin
- Site Admin
- Posts: 332
- Joined: Wed Nov 21, 2007 4:40 pm
- Location: Maysville KY
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users