Simple reverse curve yields error....
Posted: Mon Aug 17, 2009 9:50 pmCarlson Civil Suite w/ IntelliCAD
Build 090806
Command:SRCR
[end on] Select ARC at PC Start point of the curve:
ARC not selected.
quit / exit abort :error#74
Command:
It tells me that the object I am selecting is not an Arc... but it is. Sometimes it works, sometimes it doesn't.
Is there any other way to draw reverse curves?
-Eric
Build 090806
Command:SRCR
[end on] Select ARC at PC Start point of the curve:
ARC not selected.
quit / exit abort :error#74
Command:
It tells me that the object I am selecting is not an Arc... but it is. Sometimes it works, sometimes it doesn't.
Is there any other way to draw reverse curves?
-Eric