Carlson Software Forum

Good Morning I have been using Carlson for about 10 months now (after years of Civil 3D). Until last week, I was able to use the edit multiple pt attributes command with success, but now, when I close the dialog window after making changes to attributes, the edits are not applied to the points. Any ideas? Thanks in advance

Initial guesses...

First, is the program identifying the plotted point entities in the drawing as Carlson points? If you run EDITPNT and select one of the points does the typical Edit Point dialog open?


Second, when you run the EDITPNT command, note the coordinate file the point is associated with. Is it the same CRD file you have open? Likely is or I think the points would not get selected...