F2F Inspector

Moderator: Carlson Support

F2F Inspector

Postby cbnelson » Fri Feb 12, 2021 4:10 pm

Anyone getting "Missing Finish Xdata {some entity} at {some x cord.}, {some y cord.} when you run F2F Inspector?
I have a drawing with only 235 points in it and I have to wait 30 to 45 seconds while these messages scroll by each time I apply a revision to my descriptions.
Could it be a setting I do not have applied correctly.
Never under estimate an old man who is a Surveyor!
cbnelson
 
Posts: 12
Joined: Wed Aug 24, 2016 1:11 pm
Location: South Carolina

Re: F2F Inspector

Postby gskelhorn » Sat Feb 13, 2021 4:55 pm

Hey cbnelson... I do not have a delay or see any Xdata messages when using the F2F Inspector with 2020 or 2021 versions. I don't use it a lot but do recall something running into an issue where the F2F Inspector seemed to be using the first F2F code database used so if I had the wrong one picked first, then re-ran F2F with the correct database... F2F Inspector used the first database when changing descriptions after plotting points with the second database.

Doesn't sound like what you are experiencing.

F2F Inspector is working well on my current drawing... 758 points and symbols with about a dozen line strings.
gskelhorn
 
Posts: 197
Joined: Tue Nov 03, 2009 12:56 am


Return to Survey

Who is online

Users browsing this forum: Bing [Bot]