Carlson Software Forum

Morning all,

Fairly new to Carlson. So quite a few times when I plot points the Pt#, Elev and Desc rather than lining up in a nice neat row will be pancaked on top of each other or spread out.

When I go to move the point attribute it will bring them in line as they should look but this is a pain the .......

Thank you for any thoughts you may have.

Note: I'm currently update to date with the Carslon software and using Intellicad 11

I haven't seen this same issue but I have experienced something with text that might be related. I used some custom lisp routines to place, move, alight text the way I like. Lately sometimes, some text will not update the position or not to where I expect. If I move them slightly they often "snap" back into the expected position.

I haven't found a simple repeatable case. Is your issue a repeatable pattern you can file a report about.