Creating Design Contours

[Stacy]

I have a project that I'm working on in which I need to create design
contours. I'm using Carlson 2007. I have looked in the Volume 3 mannual in
the design pad template to create design contours. Can anyone tell me if
there is another way to create design contours?

Thanks,

Stacy


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.general
##-----------------------------------------------##

[Doug Sims]

Draw 2d polylines, then give them an elevation. (Either with a routine,
or with the properties dialog) That always works for me.
You can also put points in on the design elevations, draw 3d polylines
(for breaklines), then contour based on those objects.

I find its easy enough to just contour by hand on the sites I design,
(Usually really small commercial stuff).

DougS
--
This message created with an Alphagrip AG-5, 3D Keyboard & Trackball.
To learn more about the best device for comfortable computing visit:
http://www.alphagrips.com/

"Using a computer can be as comfortable as watching TV..."



Stacy wrote:

I have a project that I'm working on in which I need to create design
contours. I'm using Carlson 2007. I have looked in the Volume 3 mannual in
the design pad template to create design contours. Can anyone tell me if
there is another way to create design contours?

Thanks,

Stacy


##-----------------------------------------------##
Article posted with CarlsonSWNewGroups
http://CarlsonSWNewGroups.sourceforge.net
Share your knowledge in... carlson.general
##-----------------------------------------------##