Carlson Curve commands?

[Stephen Rhodes]

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

[Andrew Puller]

Try '2TANLTL'

Under draw, curves, 2 tangents,tangent length

"Stephen Rhodes" <stephen.rhodes@fyfe.com.au> wrote in message
news:cliufh$qt6$1@update.carlsonsw.com...

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc
length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

[Stephen Rhodes]

Thanks
"Andrew Puller" <andrew@surveyor.net.au> wrote in message
news:cln7ft$k2p$1@update.carlsonsw.com...

Try '2TANLTL'

Under draw, curves, 2 tangents,tangent length

"Stephen Rhodes" <stephen.rhodes@fyfe.com.au> wrote in message
news:cliufh$qt6$1@update.carlsonsw.com...
Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc
length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance