Unterminated complex entry

[Jeremiah Teague]

I get this error message when I try to create a curve table by picking this
line or selecting the ends and radius. What is this?

[R.K. McSwain]

"Jeremiah Teague" <jot@mmla.com> wrote...

I get this error message when I try to create a curve table by picking this
line or selecting the ends and radius. What is this?

Each 'line' in a line/curve table is a block with attributes.
The subject error message indicates that a entity was found that wasn't correctly terminated.
Most likely the table block entity, since this occurs when creating a table.

-----------------
Go into Table Defaults, change the sequence options, and exit.
The block definition will be rebuilt
Go back and set the sequence options to the way you want them.
Try again.

[Jeremiah Teague]

Thanks for the reply.

I have audited the drawing, wblocked out and started a new drawing and
purged. What do you suggest?



"R.K. McSwain" <rkmcswain@yahoo.com> wrote in message
news:c7gf02$tm5$1@update.carlsonsw.com...
"Jeremiah Teague" <jot@mmla.com> wrote...

I get this error message when I try to create a curve table by picking
this
line or selecting the ends and radius. What is this?

Each 'line' in a line/curve table is a block with attributes.
The subject error message indicates that a entity was found that wasn't
correctly terminated.
Most likely the table block entity, since this occurs when creating a table.

-----------------
Go into Table Defaults, change the sequence options, and exit.
The block definition will be rebuilt
Go back and set the sequence options to the way you want them.
Try again.

[Jeremiah Teague]

Thanks. That worked.



"R.K. McSwain" <rkmcswain@yahoo.com> wrote in message
news:c7gf02$tm5$1@update.carlsonsw.com...
"Jeremiah Teague" <jot@mmla.com> wrote...

I get this error message when I try to create a curve table by picking
this
line or selecting the ends and radius. What is this?

Each 'line' in a line/curve table is a block with attributes.
The subject error message indicates that a entity was found that wasn't
correctly terminated.
Most likely the table block entity, since this occurs when creating a table.

-----------------
Go into Table Defaults, change the sequence options, and exit.
The block definition will be rebuilt
Go back and set the sequence options to the way you want them.
Try again.

[R.K. McSwain]

What version are you running?
I'm surprised this problem still exists, it has been a known problem for years.


"Jeremiah Teague" <jot@mmla.com> wrote in message news:c7ocab$tbi$1@update.carlsonsw.com...

Thanks. That worked.